Red Shoot Ramblings. Read on if you want to learn how to use our electric hook-up facility safely and efficiently. There are two main ways you can power electrical devices on the campsite. The first is to use hook leisure battery, which is like a car battery and provides a 12V supply, and the second is an electric hook-up. Most commercial campsites in the UK will offer electric hook-ups on some or all of their pitches, we have 46 here at the Red Shoot Camping Park.
The power on our site is designed on the basis of diversity so the main site power supply is geared up to an average online dating first email example usage assuming not all hook-ups take 10A at any one time. Https://passive-income.info/aubrey-chesna-onlyfans.php, if a cold spell occurs at times of high occupancy and all users switch on electrical heaters, kettles etc.
Tripping the electrical supply can make you unpopular on site. Make no mistake about it, electricity can be dangerous, especially in the damp conditions of a tent or in the open air so safety is paramount. Even a 12V battery can give you a nasty shock if used incorrectly. Used in the right way however, you can benefit from mains electricity camping, if you take the right precautions, you can do it safely.
Follow these tips below and take professional advice from your equipment supplier to ensure your camping trip is safe and comfortable!
Quick Links
However, we have overall responsibility for the safety of our guests while on site so if we feel that any electrical equipment does not conform to safety standards or is connected to the supply in an unsafe manner, we will disconnect the camping unit. You hook use a purpose-built lead designed for bringing electricity to your unit.
These leads will have special weather-proof plugs made to connect to the sites hook-up. Hook recommend you use a cable length of 25m as the layout of some of our pitches means that you can sometimes be pitched a little distance from the hook-up bollard. These will have two or more damp-proof sockets, each of which will take an ordinary 13A plug the same as you use at home.
One of the reasons for using a properly designed electrical connection to your unit is that a Residual Current Device RCD safety device will be wired into the circuit.
Electric Hook Up: How to Use a Campsite Power Supply
This is designed to cut off the supply immediately in the case of a leakage of "camping" to earth. This can occur when someone touches hook appliance that is damp, particularly if the person is standing on damp ground.
When you are camping to connect, make sure your RCD on your unit is in the off position, then connect the lead to your unit and finally plug in to the hook-up point. Test the RCD by switching it on and pressing the test button on the unit.
How does electric hook up work?
If it fails to operate it is not safe to use and you will need to get it checked by a suitably qualified person. Tents can be damp and moisture and electricity do not mix.
The socket end of the cable will usually have some means of fixing it well above ground level. You will need to think about the equipment you want to use on site.
If you are on a campsite with a 10A supply like ours, you will have around 2. That means you could run a low watt camping or travel kettle around Watts plus a low watt toaster Watts.
But if someone then plugs in a low Watt hair dryer you are dangerously close to tripping the electrics. Of course, not all appliances are the same so the best thing to do is add up all the Watts of the appliances you want to use camping the same time, and make sure it stays below the amount of Watts 2.
We use cookies to ensure that we give you the best experience on our website. If you continue to use this site we will assume that you are happy with it.