The only thing you can't do is buy a washing machine, drive it home, and hope that it works. These dutiful appliances must first be hooked up to a water supply and drainage system. Supply pipes branch out in a basic laundry room "side" provide hot and cold water to both the utility sink and the washing machine. The drain hose of the unit clips which the side of the utility sink, which has a P-trap connecting https://passive-income.info/craigslist-greenville-upstate-sc.php a line of house drain.
Hot and cold water and a drain are required for a washing machine. You may need washer add valves for the washing machine, which look like bibs for the outdoor hose but point straight down. A standpipe hookup sink, which has a P-trap that attaches to a house drain line, is hooked to the washer drain hose.
Introduction
Several problems that lead to structural damage inside your home can be caused by water that collects around your washing machine. This indicates that pipes need to be changed and replaced with new and better connections. We explain steps that you can take to define and address this issue in this guide. Before starting this guide, shut off your water to the washer and dryer. In this guide, valves are hot. Some newer setups may use levers. Using an adjustable wrench, disconnect the pipes carefully from the water supply side and the washer side.
Найти исполнителя для моего проекта
After the pipes are disconnected, re-check the leakage and rust in the washer installation. Rotate the adjustable wrench in a counter-clockwise direction to loosen the pipe connection. Make sure to remove the old white Teflon tape. Use a bucket and a piece of cloth for water damps from the connection. Cancel: I did not complete this guide. One other person completed this guide. Badges: 6. NitWit - Nov 16, Reply. Fix Your Stuff Community Store. Introduction The only thing you can't do is buy a washing machine, drive it home, and hope that it go here. What you need.
Add a comment. Add Comment. Step 2 And the pipes. Step 3.
How to Replace Hot and Cold Water Pipes for a Washer
Step 4 Prepare the new pipes. Step 5 Wrap new Teflon tape. Step 6 Install the new pipes. Step 7 Return the water supply. One comment. Almost done! This guide contains cold steps of instructions to be followed if your pipes of the washer are needed to be changed.
Related Help Library
You're Finished! Author with 5 other contributors. One Comment. Those are hoses. Pipes are in the wall.
Single Step Full Guide. Small - px Medium - px Large - px. View Statistics:.